Pantum P2210 Series User Manual

40
4. Wired network setup (applicable to wired
network models)
In case printers support wired network printing, they can be connected to network to control printer
to print in wired network mode.
4.1. Set IP Address
The IP address of the printer may be automatically obtained through DHCP function or set
manually.
4.1.1. Automatic Setting
DHCP automatic setting function is enabled by default on the printer.
1. Connect the printer to the network through a network cable and complete the startup preparation
work.
2. The printer will receive the IP address assigned by server automatically. It may take server
minutes to receive IP address under the influence of network environment.
You can check the printer IP address through the "Info Page" (Please see "Chapter 9.1.1.3" for
printing method). If the IP address is not listed, please check the network environment or wait
several minutes and try again.
Note:
• If DHCP server fails to assign IP address automatically, the printer will get the link-local
address assigned by printer automatically: 169.25xxx.xxx.
4.1.2. Manual Setting
To set up IP address for printer through the embedded Web server manually, please refer to
Chapter 6.2.1.2 for details.

Pantum P2210 Series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Maximum Monthly Duty Cycle	15, 000 pages
Memory	128 MB
Connectivity	USB 2.0
Input Capacity	150 sheets
Output Capacity	100 sheets
Operating Systems Compatibility	Windows, Linux, MacOS
Dimensions	337 x 220 x 178 mm
Weight	4.75 kg
First Print Out Time	Less than 7.8s
Supported Media Types	Plain, Thick, Thin, Cotton, Color, Preprinted, Recycled, Bond, Label, Card, Envelope
Supported Media Sizes	A4, A5, A6, Letter, Legal, Executive
Supported Media Weight	60~163g/m²
Power Consumption	Average: 370W