5.1.1.2.Setup methods of wireless network setup tools
1. Connect the printer to computer with USB cable and then turn power on.
2. Take the wireless network setup tool in computer.
1)
Windows system: Click the “Start menu” – “All Programs” -
“Pantum”－ Product name – “Wireless Network Configuration Tool”.
2)
Mac system: Click “Go” – “Applications” – “Pantum” –Utilities–
“Wireless Network Configuration Tool” of Finder menu bar.
3.1 If wireless network is on in your computer, select the “SSID” of the wireless
network you need to connect to and then click “Next”.
Note： • The SSID you selected should be consistent with the SSID of
access point (wireless router) connected to your computer.
•
If the wireless network list is empty, please check if the access point
(wireless router) is on, or if the computer is within the wireless network
scope, and then click “Refresh” to search again.
• If the SSID you need to connect is not in the SSID list searched out,
please tick “Enter SSID Manually” to set up it manually (refer to Step 3.2.)
To Next Page
Loading...
Need help?
General