Copyright © ParTech, Inc. 2013. All Rights Reserved.Page 4 6/13/2013
Overview
This document is intended for those who are setting up PAR’s EverServ 500 terminal to run
PixelPoint Pos. You should know how to install and configure PixelPoint POS prior to reading
this document. Refer to the PixelPoint POS Installation Guide for more information.
The following chapters describe installation and configuration steps that may be needed to set
up Cash Drawer, Customer Display and MSR peripherals. In most cases, terminals ordered and
shipped through PAR will arrive ready to go, in which case this document can be used as a
reference guide. This document also contains information that can be referenced in cases
where the Operating system has been replaced or configuration changes have been made in
error.
This document contains the following sections:
System Files
PixelPoint OPOS Files
PAR OPOS Drivers
Modifying Pixel32.ini
Cash Drawer Windows Registry Configuration
Magnetic Swipe (MSR) Configuration
To Next Page
Loading...
