IMPORTANT NOTES
Please note:
Tools Required for Assembly
* Thank you for purchasing the ParaBody GS1 Gym System. Please read these
instructions thoroughly and keep them for future reference.
* Rubber mallet or hammer
* 3/4” wrench
* 9/16” wrench
* Ratchet with 3/4” and 9/16” sockets
* 5/32” Allen wrench
* Adjustable wrench
* Tape measure
3
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH RULER:
* This product must be assembled on a flat, level surface to assure its proper function. DO NOT
securely tighten any frame connections until the entire frame has been assembled, unless
otherwise stated.
Bolt Length Ruler
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
BOLT LENGTH
To Next Page
Loading...
