18 User’s Guide
4.3 REGULAR ARMING
This method, commonly used for day-to-day arming, will
arm all the zones in the selected partition.
How Do I Disarm the System?
For a Stay or Instant Armed system, go to Step 2.
1) Enter through a designated entry point (i.e. front door).
The keypad will “beep” during the Entry Delay.
2) Enter your [ACCESS CODE]
After the “CONFIRMATION BEEP”, the “ARM” Light will turn off.
IF YOU HAVE ACCESS TO BOTH PARTITIONS (see section 2.6):
3) Buttons
[1]
and
[2]
will flash. Press the button
corresponding to the desired partition. For both partitions,
press the other button after the “C
ONFIRMATION
B
EEP
”.
How Do I Regular Arm?
1) Close all zones in the desired partition.
2) Enter your [
ACCESS CODE]
IF YOU HAVE ACCESS TO BOTH PARTITIONS (see section 2.6):
3) Buttons [1] and [2] will flash. Press the button
corresponding to the desired partition. For both partitions,
press the other button after the “C
ONFIRMATION BEEP”.
1686EU04.fm Page 18 Tuesday, August 13, 2002 10:01 AM
To Next Page
Loading...
