20 User’s Guide
also be activated using Auto-Arming (see section 4.9), a
Keyswitch (see section 4.8) or One-Touch Arming (see
section 4.7).
4.4.1 Instant Arming
After Stay Arming the system and during its Exit Delay, press
and hold the [
STAY] button for 3 seconds. You should hear a
“
CONFIRMATION BEEP”. The system is then Instant Armed.
Therefore, any armed zone that is breached will immediately
generate an alarm.
If you have access to both partitions:
4.5 FORCE ARMING
Force Arming allows you to rapidly arm the system without
waiting for all zones in the system to close. During Force
Arming, a Force Zone is considered “deactivated” until it
closes, then the system will arm that zone. Force Arming is
commonly used when a motion detector is protecting the
area occupied by a keypad. For example, when arming and
To Instant Arm one partition
To Instant Arm both partitions
1) Press the [
STAY] button 1) Press the [STAY] button
2) Enter your [
ACCESS CODE] 2) Enter your [ACCESS CODE]
3) Choose a partition 3) Press [1]
4) Press the [
CLEAR] button 4) Press [2]
5) Press and hold the [
STAY] but-
ton for 3 seconds
5) Press and hold the [STAY]
button for 3 seconds
1686EU04.fm Page 20 Tuesday, August 13, 2002 10:01 AM
To Next Page
Loading...
Need help?
General
