Spectra LED Keypads 21
and the motion detector is a Force Zone, the system will
allow you to arm even if the zone is open.
When you correctly Force Arm the system, the “
ARM” Light
corresponding to the armed partition will turn on and the
Exit Delay will initiate (see section 4.1). Force Arming can
also be activated by using One-Touch Force Arming (see
section 4.7.4).
4.6 M
ANUAL
B
YPASS
P
ROGRAMMING
Manual Bypass Programming allows you to program the
alarm system to ignore (deactivate) specified zones the next
time the system is armed. For example, you may wish to
bypass certain zones when workers are renovating part of
your establishment. Please note that a Fire Zone cannot be
bypassed.
How Do I Force Arm?
1) Close zones in the desired partition (except Force
Zones).
2) Press the [
FORCE
] button
3) Enter your [
ACCESS
CODE
]
IF YOU HAVE ACCESS TO BOTH PARTITIONS (see section 2.6):
4) Buttons [1] and [2] will flash. Press the button
corresponding to the desired partition. For both partitions,
press the other button after the “C
ONFIRMATION BEEP”.
To Next Page
Loading...
Need help?
General
