Parker 3Z Series - Assembly: Endcover Bolting and Rotation; Output Shaft Endcover Bolting

HY13-1597-01/US
3Z Motor Service Procedure
3ZG Series
Parker Hannin Corporation
Hydraulic Pump & Motor Division
Greeneville, TN 37745 US
17
Assembly
NOTE
Torque Bolts into Output
Shaft Endcover
NOTE
Rotate Motor
Reinstall Drive Link
Figure31
Figure32
Greaseallsixboltsofthe
outputshaftendcoverwith
Loctitepriortowrenching/
torqueingthemdown.
(Figure31)
Insertboltsintooutputshaft
endcoverandtorquedownto
222—266lb-in.(Figure32)
Remembertotightenbolts
downinstarpattern.(Figure33)
Flipmotoroverinvicesothe
outputshaftisfacingdown.
(Figure34)
Wipesurfacecleanofoiland
debris.Then,installthedrive
link.(Figure35)
Figure34
Figure33
Figure35