4
2.2 Approvals
2.3 Materials of Construction
Safety and Electromagnetic Compatibility (EMC)
This equipment has been tested and complies with the following European Standards:
EN61010-1: 2001 — Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory use - Part 1:
General Requirements.
EN61326: 2006 — Electrical Equipment for Measurement, Control, and Laboratory use, EMC Requirements.
EN61000-3-2: 2006 — Electromagnetic compatibility (EMC) Limits. Limits for harmonic current emissions (equipment input
current = 16 A per phase).
EN61000-3-3: 1995 (+A1: 2001 + A2: 2006) — BS EN 61000-3-3:2008 Electromagnetic compatibility (EMC). Limits. Limitation of
voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current = 16 A per
phase and not subject to conditional connection.
This equipment has been tested to and complies with the following standard:
UL 61010-1 2nd Edition, “Electrical Equipment for Laboratory Use; Part 1: General Requirements.
CAN/CSA C22.2 No.61010-1 2nd Edition, “Electrical Equipment for Laboratory Use; Part 1: General Requirements.
Columns and Storage Vessels Extruded high tensile aluminium alloy, grade EN AW-6063 T6
Facia and Covers Noryl FN150 (R4G334/ AE251/1 Trimite coated)
Chassis Mild Steel (Epoxy Powder Coated)
Seal Materials Nitrile, Viton, EPDM, PTFE (tape)
Display Bezel PA-765 ABS
Display Facia Polyester film (Lumirror S10)
Compression fittings Brass
Pressure Gauge ABS Plastic casing and dial, brass connector and movement
Coalescing Filter Aluminium Housing
Solenoids Brass
Paint All external surface epoxy powder coated
Adsorbants¹ CMS (carbon molecular sieve)
Adsorbants² AA (activated alumina)
Heat Exchanger Copper Tube
Flow Controller Aluminium, brass, stainless steel, nitrile and flurocarbon
End Caps Cast aluminium – BS EN 1706-1998 ENAC 44100
Fittings Nickel plated brass
Castor Wheel Zinc chromed pressed steel and polypropylene
LISTED
LABORATORY
EQUIPMENT 84NA
To Next Page
Loading...
Need help?
General
