Parkside 100131 - Wet Vacuuming; Blow Function

9
IEGB
Vacuuming with the paper lter
bag:
To avoid the uted lter becoming
clogged, we recommend the addi-
tional use of a paper lter bag.
1. Fit the uted lter (23).
2. Fold the side aps on the paper lter
bag (24) down on the perforation.
3. Completely unfold the paper lter bag
(24) and pull it over the internal suc-
tion nozzle (8) in the stainless steel
container (9). The connector on the
suction nozzle must be completely en-
closed by the sealing ring on the lter
bag opening.
A ne dirt lter bag made of micro
lter eece is also optionally avail-
able, which can be used in place
of the included paper lter bag (see
“Spare parts/Accessories”).
Vacuuming with the dry lter
(fabric lter bag, optionally
available):
The anti-tear fabric lter bag, which is
optionally available (see “Spare parts/Ac-
cessories”), is suitable for vacuuming both
large and small dirt particles.
1. Place the foam lter (
21) on the lter
basket (
27) (see “Wet Vacuuming”).
2. Pull the fabric lter bag over the lter
basket.
Wet vacuuming
1. For wet vacuuming or to vacuum wa-
ter, t the foam lter (21) to the lter
basket (27) on the motor head (3).
To avoid tearing the foam lter (21):
- Use only a dry lter;
- Before inserting, twist the edge of
the lter slightly and then roll it back.
2. Suctioning up (draining) water: place
the suction hose (
19) on the handle
(
20) into the water tank and suc-
tion up the water.
3. Empty the stainless steel container
immediately after suction cleaning be-
cause it is not designed to store liquids
(see „Cleaning/Maintenance“).
Never reach into the water to
be suctioned up. Danger of
electric shock.
When the container ( 9) is full, the
suction opening is shut off by a oat,
and suction is then cut off. Switch the
appliance off, remove the plug from
the socket and empty the container
(see “Cleaning/Maintenance”).
If foam or liquid exits, switch off the
machine immediately.
Blow Function
Operation without the use of a lter
is recommended.
• Connect the suction hose (19) to the
connecting blower (15) on the motor
head (3).