23 GB/IE/NI
-
Ensure that there are no objects positioned
within the measurement area, which could
reflect the laser prematurely.
- The batteries must not be empty. Empty
batteries are shown in the display
2
by
the battery symbol
.
-
If a definitive measurement is not possible,
the display shows the “Err“ information.
The measurement must then be repeated.
Single distance
measurement mode
1. Slide the function switch
9
to
“DISTANCE“. The display
2
switches
itself on. You can switch between me-
ter and feet / inch. To switch between
meter and feet / inch, press and hold
the MODE button
4
. Then press the
READ button
6
and release both
buttons simultaneously. When the
buttons are released, the measurement
unit
22
will be changed.
Note: The measuring unit
22
can also
be changed after any measurement
by following above mentioned step 1.
To Next Page
Loading...
Need help?
General
