Parkside PMTS 180 A1 - Before use; Setting up the appliance; Removing;inserting transport safety devices; Operation

PMTS 180 A1
■ 10
│
GB
│
IE
│
NI
│
CY
Original accessories/auxiliary
equipment
■ Use only the additional equipment and accesso-
ries specified in the operating instructions. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
Before use
Setting up the appliance
Fix the appliance using suitable bolts (not included
in delivery) to a flat, stable base. Use the drill
holes for this purpose. Ensure that a mains
socket is within easy reach.
NOTE
► In exceptional cases you can position the
baseplate for this process on a solid support.
Removing/inserting transport
safetydevices
Removing transport safety devices
♦ Apply a little pressure to the handle
and
pull the transport safety device
out. The
motor unit
can now be moved upwards.
Inserting transport safety devices
♦ Press the handle
downwards and push the
transport safety device
into the appliance.
The motor unit
is now fixed.
NOTE
► Use the transport safety device for trans-
porting the appliance. Carry the appliance
by its integrated carrying handle
14a
.
Operation
Switching on and off
■ Direction of rotation of the tool!
■ Insert the plug into a mains power socket.
Switching on
♦ Press the ON/OFF switch
and keep it
pressed.
Switching off
♦ Release the ON/OFF switch
.
Setting the cutting depth
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
♦ Adjust the screw on the cutting depth adjust-
ment
with the aid of the supplied hex key
(small)
.
♦ Test the cutting depth by lowering the motor
unit.
Changing the cutting disc
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
► Allow the cutting disc
to cool down
before you touch it
► Check the cutting disc
. It should not be
damaged or damp, and it should have no
cracks. Otherwise, it could break during
use and cause injuries.
NOTE
► Only use cutting disks which comply with the
performance data stated in this manual.
♦ Undo the mounting screws using the
supplied hex key (small) , in order to remove
the protective cover .