Parkside PMTS 180 A1 - Introduction; Intended Use; Features; Package Contents

PMTS 180 A1
■ 2
│
GB
│
IE
│
NI
│
CY
METAL CUTTING CHOP SAW
PMTS 180 A1
Introduction
Congratulations on the purchase of your new
appliance. You have chosen a high-quality product.
The operating instructions are part of this product.
They contain important information about safety,
usage and disposal. Before using the product,
please familiarise yourself with all operating and
safety instructions. Use the product only as
described and for the range of applications speci-
fied. Please also pass these operating instructions
on to any future owner.
Intended use
The cut-off grinder is intended as a floor-mounted
appliance for making straight longitudinal cuts at
up to 45° using cutting discs in steel, nonferrous
metals, cast iron and iron profiles without the use
ofwater.
Any other uses of or modifications to the machine
are deemed to be improper usage and may result
in serious physical injury.
Not for commercial use.
Features
ON/OFF switch
Clamping flange (inside)
Spindle lock
Cutting disc
Rapid adjustment
Vice
Drillholes
Cutting angle adjustment
Transport safety device
Cutting depth adjustment
Motor unit
Handle
Figure A
Pendulum cover
Protective cover
14a
Integrated carrying handle
Mounting screws
Figure B
Clamping flange (outside)
Plain washer
Fixing nut
Figure C
Hex key (large)
Hex key (small)
Package contents
1 metal cutting chop saw PMTS 180 A1
1 cutting disc Ø 180 mm (pre-fitted)
2 Hex keys
1 set of operating instructions