Parkside PMTS 180 A1 - Clamping the workpiece; Setting the cutting angle (mitre angle)

PMTS 180 A1
GB
│
IE
│
NI
│
CY
│
11 ■
♦ Swing the pendulum cover
back completely
and hold it firmly in place with your hand.
♦ Press the spindle lock
all the way down and
hold it in this position. If necessary, rotate the
cutting disc by hand until this is possible.
♦ Use the hex key supplied (large)
to unscrew
the fixing nut out in an anticlockwise direc-
tion.
♦ Remove the plane washer
, the clamping
flange (outside)
and the cutting disc
.
♦ Insert a new cutting disc.
♦ Proceed in reverse order in order to reassemble
the appliance to a usable condition.
♦ Check whether all the fastening elements are
correctly fitted.
NOTE
► Ensure that the cutting disc can be rotated
freely.
► Switch the appliance on for around 60seconds
to check that there are no unusual vibrations.
If this is not the case, you should check that
the cutting disc is installed correctly
.
Clamping the workpiece
You can clamp the workpiece and adjust the mitre
angle with the aid of the fitted vice.
Using the vice
♦ Turn the handle on the vice
clockwise to
clamp the workpiece.
♦ Turn the handle on the vice
anticlockwise to
unclamp the workpiece.
NOTE
► You can also fold the rapid adjustment
upwards in order to make a quick adjustment
to the vice
. Fold the rapid adjustment
down again in order to fix the vice . After
this, use the vice handle to make fine
adjustments.
Setting the cutting angle (mitre angle)
♦ Undo the cutting angle adjustment
by turning
it anticlockwise. If necessary, pull the cutting
angle adjustment upwards.
♦ Set the required cutting angle using the angle
given.
♦ Retighten the cutting angle adjustment
by
turning it clockwise.
Cleaning and maintenance
WARNING! RISK OF INJURY!
► Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
■ Clean the ventilation slits in your power tool
with a soft brush regularly.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
► Required maintenance work should only be
replaced by qualified service personnel.