Parkside PNTS 1300 E4 - Troubleshooting Common Problems

13
GB IE NI CY
Trouble shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage is not present
Check plug socket, cable, line,
plug and fuse, where appropri-
ate, repair through electrical
specialist
Defective on/off switch

3)
Repair through customer service
Worn carbon brushes
Defective motor
Low or lack of suction
Hose system 
13/14) or
jets  18/20) blocked
Remove obstructions and block-
ages
Suction pipe 
12) assem-
bled incorrectly
Assemble suction pipe correctly
Container 
6) open
Close container
Container 
6) full
Empty container
Filter 
15/16/17) full or
clogged


21)

due to jerky movements)
Switch off the equipment so the
ball drops then switch on again


21) faulty
Repair by Customer Care
Float does not switch
the appliance off


21) does not move



21) faulty
Repair by Customer Care
Dust or dirt is blow
out of the device

15/16/17) is not
or not correctly assembled

