EasyManua.ls Logo

Parkside PNTS 1400 E2 - Wet Vacuuming; Blow Function; Cleaning;Maintenance; Cleaning the Device

Parkside PNTS 1400 E2
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
GB
Vacuuming ne dust:
Specic suction processes (e.g. grinding
of paints and lacquers, milling or drilling
walls, grinding or drilling hard wood) can
pose a risk from hazardous dust.
We recommend using the following option-
al lter combination, which is available,
for ne dust (see “Spare parts/Accesso-
ries”):
1. Fluted lter (23).
2. Fine dust lter bag made of eece
(optionally available see “Replacement
parts/Accessories”), which is used in
stead of the paper lter bag (24) in-
cluded in the scope of delivery.
Wet vacuuming
1. For wet vacuuming or to vacuum wa-
ter, t the foam lter (21) to the lter
basket (27) on the motor head (3).
To avoid tearing the foam lter (21):
- Use only a dry lter;
- Before inserting, twist the edge of
the lter slightly and then roll it back.
2. Suctioning up (draining) water: place
the suction hose (
19) on the handle
(
20) into the water tank and suc-
tion up the water.
3. Empty the stainless steel container
immediately after suction cleaning be-
cause it is not designed to store liquids
(see „Cleaning/Maintenance“).
Never reach into the water to
be suctioned up. Danger of
electric shock.
When the container ( 9) is full, the
suction opening is shut off by a oat,
and suction is then cut off. Switch the
appliance off, remove the plug from
the socket and empty the container
(see “Cleaning/Maintenance”).
If foam or liquid exits, switch off the
machine immediately.
Blow Function
Operation without the use of a lter
is recommended.
Connect the suction hose (19) to the
connecting blower (15) on the motor
head (3).
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
Cleaning the device
Never hose the device down with
water. Never use aggressive clean-
ing agents or solvents. This could
damage the appliance.
After use, empty the
stainless steel con-
tainer
( 9):
- Opening the drain plug to allow the
vacuumed liquid to drain out (
10). A liquid residue remains in the
container.

Table of Contents

Other manuals for Parkside PNTS 1400 E2

Related product manuals