10 GB/CY
Do not make cuts where flying
sparks could come into contact
with flammable material.
Protect yourself and others from
flying sparks and hot metal.
Please be careful because
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
Please be aware that
cutting on a ceiling, floor
or a partition can cause
a fire on the opposite side
that is not visible.
Connect the cable as practical
as possible with a socket
situated close to the workplace
to prevent the power cable
from being spread across the
whole room and located on
unknown ground which could
cause an electric shock, sparks
or fire outbreak.
Do not use the plasma cutter
to defrost frozen tubes.
Risk of electric shock:
WARNING!
f Electric shock from the
welding electrode can
be fatal.
Do not use the plasma cutter
when it is raining or snowing.
Wear dry insulating gloves.
Do not touch the electrodes
with bare hands.
Do not wear wet or damaged
gloves.
Protect yourself from electric
shock with insulation against
the workpiece.
Do not open the device
housing.
Danger from welding
fumes:
Inhalation of welding fumes
can endanger health.
Do not keep your head in the
fumes.
Use the equipment in open
areas.
Use extractors to remove the
fumes.
Danger from welding
sparks:
Welding sparks can cause
an explosion or fire.
Keep flammable substances
away from the welding
location.
Do not use the plasma cutter
near flammable substances.
Welding sparks can cause fires.
Keep a fire extinguisher close
by and an observer should
be present to be able to use
it immediately.
Safety instructions
To Next Page
Loading...
Need help?
General
