Parkside PPS 40 B2 - Introduction; Intended Use

7GB/IE/NI
Plasma cutter PPS 40 B2
• Introduction
Congratulations! You have
purchased one of our high-quality
products. Please familiarise yourself
with the product before setup or first use.
Please also read the safety instructions
carefully. This product must be set up or used
only by people who have been trained to
do so.
Keep out of the reach of children!
PLEASE NOTE!
fThe use of the term ‘product’ or
‘device’ in the following text refers to the
plasma cutter named in these operating
instructions.
• Intended use
The device is intended for compressed-air
plasma cutting of all electrically conductive
metals. Observing the safety instructions
and assembly instructions and operating
information in the instructions for use is also
a component of the intended use.
It is imperative to adhere to the applicable
accident prevention regulations. The device
must not be used:
 in insufficiently ventilated rooms,
 in moist or wet environments,
 in explosive environments,
 to defrost pipes,
 in close proximity to people with cardiac
pacemakers and
 in close proximity to easily flammable
materials.
... / Introduction
IP21S Protection class I
1 eff
Effective value of the
greatest mains current.
U
2
Standardised operating
voltage.
X % Duty cycle.
I
1 max
Greatest rated value of the
mains current.
I
2
Rated value of the cutting
current
1 ~ 50 Hz
Power input;
Number of phases and
alternating current symbol
and rated value of the
frequency.
Static frequency
converter-transformer-
commutator
U
0
Open circuit voltage
rated value
U
1
Rated value of the
mains voltage
327358_Plasmaschneider_PPS_40_B2_content_LB6_IE_NI.indb 7 06.09.2019 12:41:02