9
2.1.2 Clamping the outboard motor
1. Tighten the transom clamp screw evenly and securely. Occasionally check the clamp screws for tightness
during operation of the outboard motor because they could become loose due to engine vibration.
WARNING：
Loose clamp screws could allow the outboard motor to fall off or move on the transom. This could
cause loss of control. Make sure the clamp screws are tightened securely. Occasionally check the
screws for tightness during operation.
2. If the engine restraint cable attachment is equipped on your engine, an engine restraint cable or chain
should be used. Attach to a secure mounting point on the boat to avoid the engine being completely lost if it
accidentally falls off the transom.
To Next Page
Loading...
