6
2. Installation
2.1 Outboard motor's installation
Step 1:
Install the outboard motor at the center line of
the stern plate to ensure the balance of the ship.
If the stern plate of the ship is asymmetrical,
please consult the local dealer for guidance.
Note: Do not switch on the power supply in advance when
installing the outboard motor, so as to avoid accidents.
Step 2:
Control the height of the vortex plate of
the outboard motor at a position
greater than 150mm from the bottom
of the ship. The installation height
determines the operation efficiency of
ship. If the installation height is too
high, eddy current will be generated
and thrust will be reduced. If the
installation height is too low, water
resistance will increase, thus reducing
engine efficiency.
To Next Page
Loading...
Need help?
General
