2. Check the fuel filter periodically. If fore found in the filter, replacing it.
A diagnostic tachometer sho esults may vary depending on whether
testi
t the engine and allow it to warm up fully in neutral until it is running smoothly.
. Verify whether the idle speed is set to specification.
ign matter is
3.4 Inspecting idling speed
uld be used for this procedure. R
ng is conducted with the flushing attachment in a test tank, or with the outboard motor in the
water.
1. Star
2
Idle speed：1050±50Rpm
CAUTION:
d g speed inspCorrect i
up fully,
lin ection is only possible if the engine is fully warmed up. If not warmed
ach ground or is engaged securely.
Check that no exhaust or water he exhaust cover, cylinder head,
and body cylinder.
the idle speed will measure higher than normal. If you have difficulty verifying the
idle speed, or the idle speed requires adjustment, consult a PARSUN dealer or other qualified
mechanic.
3.5 Checking wiring and connectors
Check that e ing wire is properly secured and each connect
3.6 Checking for leakage
leaks from the joints between t
Check for oil leaks on the around the engine.
CAUTION:
If any leaks are found, consult your PARSUN dealer.
29
To Next Page
Loading...
Need help?
General
