4. Remove the oil level plug to a . llow the oil to drain completely
CAUTION:
the used oil after it has been drained. If the oil Inspect
case which
is milky, water is getting into the gear
WARNING:
can cause gear damage. Consult PARSUN dealer.
5. Use a flexible or pressurized filling device, and inject the gear oil into the gear oil drain screw hole.
6. When the oil begins to flow out of the oil level plug hole, insert and tighten the oil level plug (If
necessary, change the seal spacer).
Insert and tighten the gear oil drain screw7. (If necessary, change the seal spacer).
3.9 Cleaning fuel tank
z m sparks, cigarette s of ignition when cleaning the fuel
z Cleaning the fuel tank in a well-ventilated open air.
Keep away fro
tank.
s, flames, or other source
1. Empty the fuel tank into an approved container.
2. Pour a small amount of suitable solvent into the tank. Install the cap and shake the tank. Drain the
solvent completely.
Pull the fuel joint assembly out of the t3. ank.
33
To Next Page
Loading...
Need help?
General
