14 – English
START AND STOP
Start and stop
WARNING! Before starting observe the
following:
• Do not start the power cutter without the cutting arm,
belt or cutting head fitted. Otherwise the clutch can
come loose and cause personal injuries.
• Always move the power cutter from the fuelling area
before starting.
• Ensure that you and the machine stand firmly and that
the cutting blade rotates freely.
• Make sure no unauthorised persons are within the
working area.
!
Start
Take hold of the front handle
using your left hand. Put your
right foot on the lower section
of the rear handle pressing
the power cutter against the
ground.
Grip the starter with your right
hand, and slowly pull the
starter cord out until you feel
some resistance (the pawls
grip) now pull quickly and
powerfully.
NOTE! Do not pull out the
starter cord completely and do
not release the starter from
the fully extended position.
This can damage the chain
power cutter.
Press forward the choke
control immediately when the
engine fires and try again until
the engine starts.
When the engine starts,
quickly apply full throttle and
the starter throttle catch will
automatically disengage.
WARNING! The cutting blade can rotate when
the engine starts. Make sure it can rotate
freely.
!
Stop
The engine is stopped by
switching off the ignition
(Press the stop switch down
into the stop position.)
Starting a cold engine
IGNITION:
Slide the stop switch to the
run position.
CHOKE:
Press down the choke lever.
STARTER THROTTLE
CATCH
Press in the throttle control
and thereafter the starter
throttle catch (A). Release the
throttle control and the throttle
is blocked in half throttle
position. The catch is
released when the throttle
control is pressed in all the
way.
DECOMPRESSION VALVE
Press in the valve to reduce
the pressure in the cylinder,
this is to assist starting the
power cutter. The
decompression valve should
always be used when starting.
When the machine has
started the valve automatically
returns to its original position.
Starting a warm
engine
Use the same procedure as
for starting cold engine but
without choke. Fast idle is
recived by first set the choke
control in choke position, and
then back again.
A
To Next Page
Loading...