Partner K650 ACTIVE III - Maintenance; Daily Maintenance; Weekly Maintenance; Monthly Maintenance

English – 19
MAINTENANCE
Below follows some general maintenance instructions.
If you need further information please contact your service
workshop.
Daily maintenance
1. Check that throttle components work correctly from a safety
view point (throttle and starter throttle catch).
2. Clean the outside of the power cutter..
3. Check the tension of the drive belt.
4. Check the condition of the cutting blade.
5. Check the condition of the blade blade.
6. Check the starter and the starter cord; clean the outside of
the starter’s air intake.
7. Check that all nuts and bolts are tightened correctly.
8. Check the function of the stop switch.
9. Check the operation of the filter.
Weekly maintenance
10. Check the condition of the air filter.
11. Check that the handles and the anti-vibration elements are
not damaged.
12. Clean the spark plug. Check that the electrode gap is 0.5
mm.
13. Clean the cooling fins on the flywheel. Check the starter
and recoil spring.
14. Clean the cooling fins on the cylinder.
15. Check the muffler.
16. Check the carburettor function.
Monthly maintenance
17. Check the clutch drum, drive-pulley, and clutch springs with
regard to wear.
18. Clean the outside of the carburettor
19. Check the fuel filter, fuel hose, change if necessary.
20. Clean the inside of the fuel tank.
21. Check all cables and connections.
3
7
10
13
14
16
18
19
9
5
4
6
12
1
8
17
15
11
2
9
20