AC
Wednesday
Hopper
Cylinder
SET
=
Time
＋
＋
HOT
=
Don not serve
In refrigeration mode, press this button to adjust
the hardness value.Now SET=092
Press this button to increase the current hardness value,
each time it will be increased by the value “1”. SET=093
1
2
3
Adjusting method of the
hardness value
Note
Each raw material has an optimum hardness value
corresponding to itself. It is recommended to set
the hardness value to 100. The hardness value
should not be set too high, otherwise it may
cause Frozen Cylinder. Please strictly follow the
instructions below.
7
SET
=
SET
=
Press this button to decrease the current hardness value,
each time it will be decreased by the value “1”. SET=092
SET
=
Piston
Piston
o-ring
Washing parts
●
●
●
8
Reset ring
Nozzle
（* Applicable to gravity model）
Hoper cover
Agitator blade
Beater
Beater shaft
Nut
Clip scraper
Discharge door
Tray drip cover
Tray-drip
Air tube o-ring
Air tube
Handle
Shaft seal
Discharge door
o-ring
User notes
Please handle the parts gently and contact the manufacturers for timely replacement if it is damaged
or lost.
Do not wash parts with hot water above 40℃ to prevent parts from deformation.
Do not immerse parts in sterilizing water for more than 30 minutes.
To Next Page
Loading...
