Clip scraper
Piston
Piston
o-ring
Reset ring
Nozzle
Air pump
Washing parts
9
Feed tube
（* Applicable to air pump model）
●
●
●
Brush usage
recommendation
10
Nozzle
（* Applicable to gravity model）
Hoper cover
Agitator blade
Beater
Beater shaft
Nut
Clip scraper
Discharge door
Tray drip cover
Tray-drip
Handle
Shaft seal
Discharge door
o-ring
●
●
●
User notes
Please handle the parts gently and contact the manufacturers for timely replacement if it is damaged
or lost.
Do not wash parts with hot water above 40℃ to prevent parts from deforming.
Do not immerse parts in sterile water for more than 30 minutes.
Please use the brush attached to the kit for parts washing.
Small brush
Medium brush
Big brush
Hopper cover
Inner air tube Outer air tube Agitator blade
Discharge door Piston
Beater
Beater shaft
User notes
Please wash the parts which are connected with the raw materials carefully.
Pls be careful when washing the clip scrapers because the cutting edge is sharp. It is recommended
as well to use special disinfectant powder for washing the equipment.
The inside of the agitator blade needs to be washed carefully.
To Next Page
Loading...
