●
●
●
Recommendations for
wearing parts replacement
●
Please refer to page 22 for the
use of disinfectant powder.
●
消毒粉
12
Air pump o-ring
Stainless steel fin Nozzle
●
Please refer to page 23.24 for the
use of stainless steel fin.
●
It is recommended to clean the nozzle
every day, because it is exposured to
the air which will easily breed bacteria.
Brush usage
recommendation
Air pump Feed tube
11
Nozzle
（* Applicable to air pump model）
Please use the brush attached to the kit for parts washing.
Small brush
Medium brush
Big brush
Hopper cover
Agitator blade
Clip scraper
Discharge door Piston
Beater
Beater shaft
●
●
●
User notes
The invisible scratches on the gasket ring may cause the problem of "ice cream leakage".
Therefore, it is recommended to replace the o-rings every 3 months.
Please replace them right away once you find scratches on them.
Air tube o-ring
Piston o-ring
Discharge door o-ring
Shaft seal
The clip scraper wear may cause the
ice cream to be too soft and forzen
cylinder.Therefore, it is recommended
to be replaced every 6 months.
Please replace it right away if it’s
found seriously worn.
If the washing brush is worn or fallen off, it may cause problems such as' poor washing '. When this happens,
please replace with the new brush in time.
Small brush Medium brush
Big brush
Clip scraper Food grade lube
The gasket rings shown
above need to be coated
with proper amount of
lubricant before installation.
Disinfection powder
Please wash the parts which are connected with the raw materials carefully.
Pls be careful when washing the clip scrapers because the cutting edge is sharp. It is recommended
as well to use special disinfectant powder for washing the equipment.
The inside of the agitator blade needs to be washed carefully.
To Next Page
Loading...
