To Next Page
A
ashleemartinezSep 23, 2025
What does 'water stains' mean for Passion R06SPA Heat Pump?
- DdjensenSep 23, 2025
No action.
What does 'water stains' mean for Passion R06SPA Heat Pump?
No action.
What to do if my Passion R06SPA Heat Pump is not running?
If the heat pump is not running, it might be under standby status. Startup the heat pump to run.
What to do if my Passion Heat Pump has a water flow failure?
In case of water flow failure, check the water flow or switch.
Why is my Passion R06SPA Heat Pump water temperature cooling when running under heating mode?
If the water temperature is cooling when the heat pump runs under heating mode, you might have chosen the wrong mode. Adjust the mode accordingly.
What to do if my Passion R06SPA shows a high pressure failure?
If there is a high pressure failure: 1. Discharge redundant refrigerant from the heat pump gas system. 2. Clean the water exchanger or water filter.
What to do if my Passion Heat Pump has too high heating outlet water temperature protection?
Check whether the water flow or water system is jammed or not.
What does Passion R06SPA Heat Pump winter anti-freezing do?
The water pump will run automatically for first grade antifreeze.
What to do if my Passion R06SPA has too low cooling outlet water temp protection?
Check whether the water flow or water system is jammed or not.
What should I do if my Passion R06SPA Heat Pump's water inlet temperature fails?
If the water inlet temperature fails, check or change the sensor.
What to do about too much ice on the evaporator of my Passion Heat Pump?
If there is too much ice on the evaporator: 1. Check the location of the heat pump, and eliminate all obstacles to assure good air ventilation. 2. Replace or repair the heat pump.
General notes and important points regarding the installation of the heat pump.
Guidelines for selecting the optimal placement for the heat pump unit.
Instructions and diagrams for connecting the heat pump's electrical components.
Step-by-step procedure for starting and operating the heat pump for the first time.
Explanation of condensation formation on the evaporator fins during operation.
General features and capabilities of the LED display controller for the heat pump.
Diagram illustrating the control principle between the heat pump and the wire controller.
Detailed instructions on using the wire controller interface, its icons, and operating keys.
Procedure for manually activating the electric heater function of the heat pump.
Steps to initiate the enforced defrosting mode for the heat pump unit.
Procedure to reset the heat pump's settings back to their original factory defaults.
Instructions for accessing and adjusting various system parameters for optimal performance.
Information on error codes, their descriptions, and recommended solutions for system protections.
Troubleshooting common malfunctions and their solutions when the LED wire controller has no display.
General