To Next PageTo Next Page
Need help?Do you have a question about the PassTime GPS PTE-2 and is the answer not in the manual?
Provides instructions for mounting the GPS unit within the vehicle's dash.
Details pre-installation steps, including recording unit and vehicle information.
Lists the items included with each GPS unit package.
Guides the installation of the 5-wire PassTime Device Harness.
Outlines the necessary electrical connections for proper device installation.
Details connecting the black ground wire, including soldering and ground point selection.
Explains how to connect the pink ignition wire and verify vehicle ignition signals.
Instructions for cutting and connecting vehicle starter wires with the harness.
Details connecting the red wire to a constant 12v power source in the vehicle.
Guides the placement and mounting of the GPS unit module within the vehicle's dash.
Details the final testing procedures and product registration steps.
Provides general information about the GSM terminal and cellular technology.
Discusses public concerns and research regarding RF energy exposure from GSM terminals.
Offers guidelines for operating the GSM terminal efficiently to minimize RF exposure.
Describes the modular transmitter's usage, antenna gain limits, and operating conditions.
Details compliance with FCC and Industry Canada regulations for the device.
Outlines the terms and conditions covered by the PassTime limited warranty.
Specifies what is excluded from the PassTime limited warranty and its limitations.
Provides instructions on how to request warranty service and obtain an RA number.
General| GPS Accuracy | 2.5 meters CEP |
|---|---|
| Antenna | Internal |
| Update Rate | 1 Hz |
| Acquisition Time (Hot Start) | 1 second |
| Humidity | 5% to 95% non-condensing |
| Baud Rate | 9600 bps |
| Protocol | NMEA 0183 |
| Operating Temperature | -20°C to 60°C |
| Acquisition Time (Cold Start) | 29 seconds |
| Storage Temperature | -40°C to +85°C |
