Paul FOCUS 200 Base

To Next Page

To Previous Page

Version: 1.0_06/2016 DE

Preamble

Thank you for deciding on the heat recovery unit FOCUS 200 base

Legal provisions

This operating manual has been compiled with the greatest care. However, the editor does not assume

any liability for damages resulting from missing or incorrect information contained in this operating

manual. We reserve the right to change the content of this manual partially or completely at any time

without prior notification.

The information contained in these documents is the property of PAUL Wärmerückgewinnung GmbH.

The publication, whether partially or completely, requires the written consent of PAUL

Wärmerückgewinnung GmbH. Any in-house reproduction intended to evaluate the product or for proper

use is permitted and is not subject to approval.

Trademarks

All trademarks are acknowledged, even if they are not labelled separately. A missing labelling does not

mean that a good or sign is free of trademark rights.

Validity

This document applies to the following types of devices:

 FOCUS 200 Base - series (Zehnder FOCUS 200 Base – series)

The types of device FOCUS 200 Base, are hereinafter referred to under the product name FOCUS,

unless details are for type differentiation.

The heat recovery unit (HRU) FOCUS has been built according to the current state of the art and the

acknowledged rules on safety. The device is subject to permanent improvement and development.

Therefore, your device may differ slightly from the instructions.

In order to guarantee a safe, appropriate and economic operation of the heat recovery unit FOCUS,

please observe and comply with all information and notes on safety in this operating manual.

Subject of this operating manual is the heat recovery unit FOCUS in different design variants. Possible

accessories are only described insofar as it is necessary for the appropriate operation. Please see the

particular manuals for further information on accessories.

Target group

The operating manual is intended for operators and qualified personnel. The activities may only be

carried out by personnel having a corresponding formation and being sufficiently qualified for the

respective work.

Besides the general section 1 Introduction, this manual consists of:

 A part for the operator and qualified personnel  section 1 and 2

 A part specifically intended for qualified personnel  section 1 and 3

Paul FOCUS 200 Base - Page 2