Pavone Systems DAT 1400 - Diagram of the Menu

WEIGHT VALUE
CAL1br rEsoLU L.C. Cap. L.C. SEn. Syst.FS dEad L. CAL.typ.
AnALoG. CoN.Por.
C1 Nod. C1Prot. C1baUd C1ForN. C2 Nod.
FUn.1n.1 FUn.1n.2 NodE 1 Hyst. 1 t1NEr1 dELay1 NodE 2 Hyst. 2 t1NEr2 dELay2
ParaN.
Notion
auto-0 0-traC. 0-band
FILtEr diG.ban.
C. ratE avEraG. Nonot. t.osC1L. r.osC1L.
FUnCt.
ranGE NodE An 0 An FS 0 AdJ. FS adJ. C2Prot.
C2bAUd. C2ForN. C2Addr.
std. by
Lock PIn.Cod. PEak. dat.LoG. LoG.trG.
LoG.Fr9.
0 CaL P1 CaL
1n-oUt
dEad W. tabLE
0 VaL 0 SIG
p5 CaL P1 SIG p5 SIG p5 SIG
P5 VAL P1 VaL P1 SIG
StorE? sEtUP
1nfo tEst SEtup
ENTER IN SET-UP MENU
F
3 sec.
ENTER MENU
WEIGHT VALUE
+
3 sec.
En.Fbus 1nP.rEG. oUt.rEG.
En.Fbus
1P SubnEt GAtE. Port Eth.Pro.
COM2 RS485 COM2 PROFINET / ETHERCAT
COM2 ETHERNET IP
COM2 ETHERNET
1P SubnEt 1nP.rEG. oUt.rEG.
IN VIOLET SUBMENU VISIBLE ONLY IF OPTION IS INSTALLED
6 sec.or
En.Fbus
En.FbuS
Addr.Co baud.Co.
COM2 PROFIBUS
COM2 CANOPEN
Addr.Pr
ENTER IN TEST MENU
ENTER IN INFO MENU
CLoCt ACCESS ALi.NEN. datE ACC-01 000000
t1NE ACC-02 0.000
ACC-03 no Cod. ACC-04 ACC-05
uPL.dow ACC-01
ACC-02 ACC-03 ACC-04 ACC-05
GEt 0
Page 27
DIAGRAM OF THE MENU