Page 44
INPUT/OUTPUT PARAMETERS
FUn.1n.1
INPUT 1 FUNCTION
Selecting the function associated with input 1. [1401]
Values that can be selected:
Zero: It calibrates to zero. [0]
Tare: It executes the automatic tare. [1]
Del.Tar: It cancels the tare. [2]
Peak: Reset of the peal function. [3]
Hold: Holds Acquired Weight. [4]
Send: Data transmission on demand. [5]
Log: Activates the datalogger function. [6]
Default: Zero
FUn.1n.2
INPUT 2 FUNCTION
Selecting the function associated with input 2. [1402]
Values that can be selected:
Zero: It calibrates to zero. [0]
Tare: It executes the automatic tare. [1]
Del.Tar: It cancels the tare. [2]
Peak: Reset of the peal function. [3]
Hold: Holds Acquired Weight. [4]
Send: Data transmission on demand. [5]
Log: Activates the datalogger function. [6]
Default: Zero
NodE 1
SET-POINT 1 OPERATING MODE
Select in sequence 4 operating criteria of set-point 1: [1403]
Comparison with net weight, with gross weight or with peak. In the latter case the comparison is carried
out with the last acquired peak value, even when the peak function is not active.
NET The relay output is active in Net Weight mode. [0]
GROSS The relay output is active in Gross Weight mode. [1]
PEAK The relay output is active in Peak mode. [2]
PROCESS The relay output is active when the instrument is working normally. [3]
Default: GROSS
To Next Page
Loading...