Pax Technology D220 - 8.1.3 Wi-Fi Proxy Server (Manual Setup)

PAX D220 Quick Setup Guide
P
AX Technology® 9 20180801 v1.1
support@pax.us
(877) 859-0099
www.pax.us
Select the Subnet Mask option, input the
Subnet Mask, and press the “Enter” button.
Select the Gateway IP option, input the
Gateway IP, and press the “Enter” button.
Select the DNS IP option, input the DNS IP, and
press the “Enter” button.
Wi-Fi Proxy Server (Manual
Setup)
If you are required to setup a Wi-Fi connection via a
proxy server, perform the steps in this section.
Before you begin configuration, ensure that you
have the correct network information; URLs,
Address, Subnet mask, Gateway ID, passwords, etc.
Perform Steps 1 through 6 as shown in Section
8.1 D220 Basic Wi-Fi Setup.
After selecting the Wi-Fi parameters option
(Step 6), use the Right Arrow on the screen,
navigate to and Host Settings option.
Input the case-sensitive password and press
the Enter button.
Select the Host URL Params option.
Select the Auth. URLs option.
Select the Host URL 1 option.
Select the Host URL option and input the host
URL.
Press the Enter button.
Select the Host Port option and input the host
port.
If required, repeat Steps 7 through 9 for the
Host URL 2 option.