PAX A920 - Installing the Terminal Silicone Sleeve

Terminal Charging
Base for PAX A920
Installation Guide
Copyright© 2021 PayFacto Inc. Page 6of10
1.
2.
3.
Installing the Terminal Silicone Sleeve
To protect your PAX A920 terminal from minor impact damage, you should install the silicone sleeve provided
with the terminal charging base as the charging base is designed specifically for terminals with the sleeve.
To install the silicone sleeve:
Insert the top of the terminal under the front-facing camera protection until the sleeve fits snugly onto
the terminal’s top.
Pull the bottom of the sleeve over the bottom edge of the terminal.
Repeat for any additional terminals you intend to place on the charging base.
NOTE: To add or change a SIM card, you need to remove
the sleeve from the terminal.