PAGE 11
The use of any add-on, expansion, memory or other module manufactured or supplied by the manufacturer's
representative will invalidate the CAN/ULC-S319 certication.
For CAN/ULC-S319 installations, terminals, leads and wiring methods must comply with CSA, C22.1, Canadian
electrical code, Part 1, safety standards for electrical installations.
Product compliance and limitations
To comply as a UL listed installation, the following conditions must apply:-
Server based functions (Antipassback, Time and Attendance, etc) have not been evaluated by UL and cannot be used
for UL 294 installations.
The use of Wiegand readers and the conguration software has not been evaluated by 'UL'
Wiring: - Where an equivalent cable / wire is used it must be ' UL Listed '
All interconnecting devices must be UL Listed.
Exit buttons - A UL listed 'push to make' button must be used.
Door contact - A UL listed 'Normaly Open' (N.O.) switch must be used.
Tamper alarm - Connect to a UL listed burglar alarm unit for supervision.
Alarm sounder - Connections to this alarm output have not been evaluated by UL for burglar alarm use.
Break glass- A UL listed break glass must be used.
Fire door interface - This feature has not been evaluated by 'UL' and must not be used in UL-294 installations.
Intruder alarm integration - This feature has not been evaluated by 'UL' and must not be used in UL-294 installations.
The power must be provided via a separate DC supply, a UL Listed Access Control (or Burglar Alarm) Class
2, Power-Limited, power source capable of 4 hours standby must be employed. This is wired into the 0V
and 12/24V terminals and the cable secured with the cable ties provided.
Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local codes, and the
authorities having jurisdiction.
Software features and functions have not been evaluated by UL.
Class B digital devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
To Next Page
Loading...
Need help?
General
