PBI SAS SUPER IAQ - Utility Mode Program Functions

“SAS Super IAQ” Rev. 1 Pg. 10
ENGLISH
Press ENTER. Note the display will still show the old volume before modification.
To verify the selected volume,
look at the
S T A R T F O R X X X X
USER MODE Program
M / D / Y - H / M
4.4 “UTILITY MODE” PROGRAM
In this program the following SUB-MENUS are listed:
Set time; Sampling site; Identify; Language; Clear Record; Display Record; Set Autoswitch.
Always start from UTILITY MODE to reach one of these SUB-MENU.
ACTION DISPLAY
Switch on the Main ON/OFF
switch (black button) and press
U T I L I T Y M O D E
“¿” to reach UTILITY MODE.
M/ D / Y - H / M
4.4.1. “SET TIME”
This option is used to program day, month, year and time of the day
ACTION DISPLAY
Press ENTER to select
SE T TI ME
the “SET TIME” Sub-Menu
M/ D / Y - H/ M
Press ENTER and “¿” to change month
Press ENTER and “¿” to change day
Press ENTER and “¿” to change year
Press ENTER and “¿” to change hours
Press ENTER and “¿” to change minutes
ACTION DISPLAY
Press ENTER to confirm
U T I L I T Y M O D E
M/ D / Y - H / M
4.4.2. “SAMPLING SITE”
This data is memorized in the file “DISPLAY RECORD” (see paragraph 4.4.6). The site
identification should be changed for samples taken at different sites especially if the results are
to be printed.
Select UTILITY MODE Program.