PBI SAS SUPER IAQ - Low Battery Message and Remote Switch Use

“SAS Super IAQ” Rev. 1 Pg. 15
ENGLISH
* *
D ELAY
* *
( X X ) X X
M / D/ Y - H/ M
4.6 Low Battery Message
When the LOW BATTERY message is flashing, the air sampler must be connected to the
battery charger. The residual charge may be enough to complete the last sample, but this will
vary according to the condition of the battery (age, use, temperature, etc.).
ACTION DISPLAY
Switch on the ON/OFF
! ! L O W B A T T E R Y ! !
switch (black button)
4.7. “REMOTE SWITCH” USE
The SAS SUPER IAQ microbiological air samplers can be fitted with an Infrared Remote
Control (optional).
The instrument, in normal operating conditions, automatically switches off after 4 minutes, to
save the battery, if the unit is
not being used. It is therefore necessary to disable the
“autoswitch off” in case the Infrared Remote Switch is used after 4 minutes.
The following protocol shows how to disable the auto-switch off option.
ACTION DISPLAY
Switch on the ON/OFF
S TAR T FOR XX
switch (black button)
M/ D / Y - H/ M
Press “¿” to select
U T I L I T Y M O D E
UTILITY MODE
M/ D / Y - H/ M