41
L510010-03
C.C.
ENGINE MAINTENANCE - 11
8. Lubricate the new O-ring with a light grease and
install the new O-ring into the FCC bowl mounting
head.
9. Apply pipe sealant, suitable for use with gasoline,
to the threads of the 7/16” plug.
10. Install and tighten the 7/16” plug while holding the
3/4” jam nut with a wrench.
11. Grease taper and the threads on the FCC bowl
and, by hand, thread the FCC bowl into the FCC
mounting head. Tighten the bowl fi rmly back into
the mounting head with an oil fi lter wrench.
12. Reconnect the two-wire electrical connector.
13. Cycle the ignition key several times to run the
electric fuel pumps and fi ll the FCC bowl with
fuel. Inspect the drain plug area for leaks. Correct
any leaks prior to operating the engine.
14. Start the engine and inspect for fuel leaks.
Correct any leaks prior to operating the engine
any further.
DO NOT ATTEMPT TO SERVICE ANY OTHER PARTS
ON THIS UNIT.
To Next Page
Loading...
Need help?
General
