EasyManuals Logo

PCM 2003 5.0L MPI User Manual

Default Icon
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
47
L510010-03
C.C.
ENGINE MAINTENANCE - 11
CHANGING OILS
WARNING
IMPORTANT: The Federal Water Pollution Control
Act prohibits the discharge of oil or oily waste into
or upon the navigable waters and continuous zone
of the United States, if such discharge causes a
lm or sheen upon, or discoloration of the surface
of the water, or causes sludge or emulsion beneath
the surface of the water. Violators are subject to a
penalty of $5,000.00.
Refer to the MAINTENANCE SCHEDULE for oil change
intervals. The engine and transmission oils should be
changed prior to placing the boat into storage.
The transmission oil change should be performed by an
authorized dealer, at specifi ed intervals.
IMPORTANT: Change the engine oil when the engine
is warm from operation. Warm oil fl ows more freely,
and allows more foreign material and impurities to be
removed.
The engine oil fi lter is remote mounted. The engine block
location, where the fi lter is normally mounted, is covered
with an oil fi lter bypass adapter. DO NOT remove this
adapter when changing the oil.
1. With the engine at normal operating temperature,
remove the dipstick and install a crankcase oil
pump onto the dipstick tube (Figure 11-19).
Insert the discharge hose into a suitable
container. Pump the oil from the engine until the
crankcase is empty. Remove the oil pump from
the dipstick tube.
2. Remove the oil fi lter by turning it
counterclockwise, using an oil fi lter wrench if
necessary. Discard the old fi lter and sealing ring.
3. Coat the sealing ring, on the new fi lter, with
a light coating of clean engine oil. Install the oil
lter securely by hand. DO NOT overtighten.
4. Fill the engine with the recommended oil, see
OIL REQUIREMENTS, through the oil fi ll location
on the valve cover (Figure 11-20).
Figure 11-19 Engine Oil Removal
Figure 11-20 Engine Oil Fill (8.1L)
5. Start the engine and operate for 5 minutes to
circulate the oil throughout the engine. Check
entire system for leaks, especially around the oil
lter.
6. Stop the engine and wait 5 minutes to allow the
oil to completely drain down. Check the oil level
and add oil, if needed, to bring the engine oil to
the proper level.
OIL FILL
CAP
OIL PUMP
CONTAINER
DIPSTICK

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PCM 2003 5.0L MPI and is the answer not in the manual?

PCM 2003 5.0L MPI Specifications

General IconGeneral
BrandPCM
Model2003 5.0L MPI
CategoryEngine
LanguageEnglish

Related product manuals