-11-
1. Safety precautions
This product complies with the requirements of the following
directives of the European Union for CE conformity: 2014/30/EU
(electromagnetic compatibility), 2014/35/EU (low voltage),
2011/65/EU (RoHS).
Overvoltage category II 600 V; pollution degree 2.
CAT I: For signal level, telecommunication, electronic with small
transient overvoltage
CAT II: For local level, appliances, main wall outlets, portable
equipment
CAT III: Distribution level, fixed installation, with smaller transient
overvoltages than CAT IV.
CAT IV: Units and installations, which are supplied overhead lines,
which are stand in a risk of persuade of a lightning, i.e. main-
switches on current input, overvoltage-diverter, current use
counter.
To ensure safe operation of the equipment and eliminate the danger
of serious injury due to short-circuits (arcing), the following safety
precautions must be observed. Damages resulting from failure to
observe these safety precautions are exempt from any legal claims
whatever.
* Do not subject the equipment to direct sunlight, extreme
temperatures, extreme humidity or dampness
* Do not operate the equipment near strong magnetic fields
(motors, transformers etc.)
* Do not subject the equipment to shocks or strong
vibrations
* Keep hot soldering iron or guns away from the
equipment
* Allow the equipment to stabilise at room temperature before
taking up measurement (important for exact measurement)
* Do not modify the equipment in any way
* Opening the equipment and service- and repair work must only
be performed by qualified service personnel
* Measuring devices don’t belong to children hands
To Next Page
Loading...
Need help?
General
