Need help?Do you have a question about the Peavey 260 and is the answer not in the manual?
Warning against exposing the appliance to rain or moisture to prevent electrical shock or fire hazard.
Conventional 50K audio taper pot for input preamp, offering infinite dynamic range.
Twin standard ½" jacks with unique switching for parallel operation and noise minimization.
Simple on/off switch for compression circuitry, indicated by an LED.
Active high pass filter with variable 12 dB/octave rolloff between 20 Hz and 200 Hz.
Parallel ½" jacks with 600-Ohm output impedance, nominal output capability of 2 Volts RMS.
Fuse location within the fuseholder cap, requires proper type and value for safety and warranty.
Three-position switch (domestic) or simple on/off (export) for unit power control.
Three-wire line cable with proper grounding facilities for safety and noise reduction.
Parallel standard ½" jacks optimized for 4-Ohm load, drives loads above/below with caution.
Molded retainers for mains cable storage during travel; unwrap for heat dissipation during operation.
Warnings regarding hearing loss from high noise levels and safe operating practices.
Instructions for safe operation including water proximity, ventilation, heat sources, and servicing.
Details power output, sensitivity, input/output impedance, gain, equalization, and low-cut filter.
To Next Page
General
