EasyManuals Logo

Peavey GPS Series User Manual

Peavey GPS Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
GPS
900 SPECIFICATIONS
OUTPUT POWER: (Typical value) Stereo mode, both channels driven
2 ohms, 1 kHz, .1 THD - 450 WRMS per channel
4 ohms, 1 kHz, .1 THD - 330 WRMS per channel
8 ohms, 1 kHz, .1 THD - 200 WRMS per channel
Bridge mode, mono
4 ohms, 1 kHz, .1 THD - 900 WRMS
8 ohms, 1 kHz, .1 THD - 660 WRMS
RATED OUTPUT POWER: Stereo mode, both channels driven
4 ohms, 20 Hz to 20 kHz,0.03% THD - 300 WRMS per channel
8 ohms, 20 Hz to 20 KHz,0.02% THD - 170 WRMS per channel
SLEW RATE: (Typical value)
Stereo mode, each channel - 40 Volts per usec
Bridge mode, mono - 80 Volts per usec
INPUT SENSITIVITY AND IMPEDANCE:
Input attenuator set @ FCW
@ rated output power, 4 ohms - 0.90 VRMS (-1 dBV)
Unbalanced, 1/4" phone jack - 20 k ohms
Balanced, XLR (phase selectable) - 10 k ohms per leg
Overall system gain per channel - 40X (+32 dB)
FREQUENCY RESPONSE: (Typical) Stereo mode, both channels driven
+0,-1 dB, 1 WRMS, 4 ohms - 5 Hz to 50 kHz
+0,-0.2 dB @ rated output, 4 ohms - 20 Hz to 20 kHz
DAMPING FACTOR: (Typical value) Stereo mode, both channels driven
8 ohms, 1 kHz - Greater than 400
HUM AND NOISE: Stereo mode, both channels driven
Below rated output power, 4 ohms - 100 dB @ 120 volts
POWER CONSUMPTION: Stereo mode, both channels driven
@ 1/8 rated power @ 2 ohms - 540 watts @ 120 VAC
WEIGHT: - 35.8 lbs. (16.2 kg)
15
Specifications subject to change without notice.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Peavey GPS Series and is the answer not in the manual?

Peavey GPS Series Specifications

General IconGeneral
Channels2
Rack Spaces2U
InputsXLR, 1/4"
OutputsSpeakon, Binding Post
ProtectionThermal, short circuit
Dimensions19" (483 mm) W

Related product manuals