Peavey ICS 4200

ICS
™
4200 4-Channel Power AmplifierUser Manual

Peavey ICS 4200 Specifications

General

Channels	2
Frequency Response	20 Hz - 20 kHz
Cooling	Variable speed fan
Type	Power Amplifier
Signal to Noise Ratio	> 100 dB
Total Harmonic Distortion	< 0.05%
Inputs	XLR, TRS
Outputs	Speakon
THD	<0.05%
Input Impedance	20k Ohms

Summary

Safety Warnings and Symbols

General Safety Precautions

Explanations of warning symbols and fundamental safety directives for operation.

Important Safety Instructions

Operating Safety Guidelines

Comprehensive list of crucial safety instructions for using the amplifier.

Operating Precautions

General Operation Advice

Front Panel Components

Clip (SPS) Indicators

Input Level Controls

Rear Panel Connections

Channel AB Output Selector

Switch to configure channels A/B for Low Z or 70 Volt operation.

Channel CD Output Selector

Switch to configure channels C/D for Low Z or 70 Volt operation.

Channel AB Outputs

Screw-terminal outputs for connecting loudspeaker systems to channels A/B.

Channel CD Outputs

Screw-terminal outputs for connecting loudspeaker systems to channels C/D.

Channel Inputs

MMA Plug-in Module Ports

Module Output to Channel Selectors

Input Configuration

Input Connections

Input Modules and DIP Switch Settings

Mode Configurations

Input Modes

Describes how to connect inputs for Dual-Dual Mono, Parallel, and Bridged operation.

Dual-Dual Mono Mode

Parallel Mode

Bridged Mode Operation

Bridged Mode Details

Instructions for bridging channels to create a single higher-power output.

Output Modes

Low Z Mode Configuration

Configures outputs for driving 4 or 8 Ohm loudspeaker loads.

70 V Mode Configuration

Configures outputs for driving 70 Volt constant-voltage audio distribution systems.