5
(6) POST GAIN
is control, on the CRUNCH and LEAD channels, sets the overall level of its respective channel.
(7) LOW, MID, and HIGH EQ
ese passive controls, on both the Crunch and Lead channels, provide the signature tone print of the Invective
120.
(8) PRE GAIN
is control, on both the Crunch and Lead channels, controls the input volume level/gain of its respective chan-
nel. is control will increase the amount of preamp distortion and sustain.
(9) BOOST SECTION
is group of controls dictates the sound of the switchable BOOST section of the CRUNCH and LEAD chan-
nels. is is an input volume boost which pushes the high gain section of the amp to work against the gate for
maximum edge.
(10) GATE THRESHOLD
Turning up this switchable control, on both the CRUNCH and LEAD channels, controls the level at which the
input gate triggers to mute the incoming signal.
(11) CHANNEL
is momentary switch allows selection between the three channels. CHANNEL ACTIVATION LEDs indicate
which channel is active. Channel switching can also be accomplished from the included footswitch.
(12) VOLUME
is control, on the CLEAN channel, sets the overall level going to the power amp.
(13) LOW, MID, and HIGH EQ
ese passive controls provide the desired EQ curve for this channel.
(14) PRE
is knob controls the input sensitivity of this channel.
(15) BOOST SECTION
is group of controls dictates the sound of the switchable BOOST section of the CLEAN channel. is is an
input gain boost which pushes the clean section of the amp into classic overdrive territory.
(16) INPUT
is ¼” jack is designed to accommodate signals from any electric guitar, with active or passive pickups.
To Next Page
Loading...
