Peavey Invective 120 - Footswitch Presets and Modes; Drive Boost and Channel Selection; Master Boost and Preset Storage; Using and Storing Presets

10
(37) Drive Boost / Preset #5
NORMAL mode: is turns Drive BOOST on and o for the current channel. When switching between chan-
nels, this will remember what the last setting was for each. e LED will be green when Drive BOOST is on.
PRESET mode: is selects Preset 5. If selected, the LED will be red.
(38) Channel Select 1 / Preset #6
NORMAL mode: is selects Channel 1. e LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. is allows quick changing between two channels using a single switch.
PRESET mode: is selects Preset 6. If selected, the LED will be red.
(39) Channel Select 2 / Preset #7
NORMAL mode: is selects Channel 2. e LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. is allows quick changing between two channels using a single switch.
PRESET mode: is selects Preset 7. If selected, the LED will be red.
(40) Channel Select 3 / Preset #8
NORMAL mode: is selects Channel 3. e LED will be lit GREEN. If pressed a 2nd time, the channel will
return to the previous setting. is allows quick changing between two channels using a single switch.
PRESET mode: is selects Preset 8. If selected, the LED will be red.
(41) Master Boost / Preset #9
NORMAL mode: is turns the Master Boost on and o. e LED will be lit green.
PRESET mode: is selects Preset 9. If selected, the LED will be red.
Each of the 9 presets remembers the current channel, drive boost on/o, gate on/o, CC4 on/o, eects loop on/
o and master boost on/o. Additionally, it remembers the drive boost and gate status of the inactive channels.
is way you can, for example, have a clean preset saved without drive boost, and know that when you switch to
Channel 2, drive boost will be on.
e amp comes from the factory with 9 default presets that you can modify at will. When the PRESET MODE
light is on, you can use the 9 other footswitches to recall those 9 presets. At any time you can switch to NOR-
MAL mode and make changes to that sound. is can be during a performance and not permanently stored, or
to edit a preset and store to one of the 9 settings.
To store the current settings into one of the 9 presets, you start by holding the PRESET MODE switch down for
a second or two, aer which the other LEDs will blink (except the one for the current preset which will be on
steady – a way to remind you of which preset you were working with). At this point you can press one of the 9
preset switches to store there, or press PRESET MODE again to cancel.
USING PRESET MODE
STORING PRESETS