Peavey Invective 120 - Footswitch Operation; Remote Cable and Preset Mode; Channel and Effects Loop Control; Preset Recall Functions

9
FOOTSWITCH
(31) Remote Cable
An eight-pin DIN connector is provided for connecting the footcontroller to the amplier IN/FOOT (38) via the
cable included in the carton.
(32) Preset Mode
Switches the footcontroller between NORMAL mode (default, LED o) and PRESET mode (LED red). Other
LEDs will be red for Preset Mode, and green for Normal Mode. (See “Using Preset Mode” section on pg. 10)
(33) Eects Loop 1 / Preset # 1
NORMAL mode: is turns on Eects Loop 1.
PRESET mode: is selects Preset 1. If selected, the LED will be lit red.
(34) Eects Loop 2 / Preset # 2
NORMAL mode: is turns on Eects Loop 2.
PRESET mode: is selects Preset 2. If selected, the LED will be red.
(35) Gate / Preset # 3
NORMAL mode: is turns on the gate circuit when using Channel 2 or 3.
PRESET mode: is selects Preset 3. If selected, the LED will be red.
(36) MIDI CC4 / Preset #4
NORMAL mode: is will send MIDI controller 4 with data 0 (LED o) or 127 (LED on) to control external
MIDI gear.
PRESET mode: is selects Preset 4. If selected, the LED will be red.
31
37 38 39 40 41
32 33 34 35 36