Need help?Do you have a question about the Peavey Invective 120 and is the answer not in the manual?
General| Power Output | 120 Watts |
|---|---|
| Preamp Tubes | 6 x 12AX7 |
| Type | Tube Amplifier |
| Channels | 2 |
| Effects Loop | Yes |
| EQ | 3-band EQ |
| Footswitch I/O | 1 x 1/4" Footswitch Input |
Controls for powering the unit on/off and engaging standby mode.
Controls overall output level and power amp response (Resonance/Presence).
Connects footcontroller or MIDI devices via 8-pin DIN and 5-pin DIN ports.
Provides 9VDC power and series connections for external effects processors.
Adjusts footswitchable post-EQ volume boost level.
Mic-simulated output and jacks for connecting speaker cabinets.
Settings for speaker impedance matching and amplifier output power.
Protects the amplifier and provides the main power input.
Procedure for adjusting power tube bias, requiring technical expertise.
Locations for measuring power tube plate current for technician use.
Connects the remote footswitch and selects operating modes.
Switches channels and activates effects loops via footswitch.
Recalls presets 1 through 4 and controls MIDI CC4.
Controls Drive Boost, channel selection, and recalls presets 5-8.
Controls Master Boost, recalls Preset 9, and details preset storage.
Guides on recalling, modifying, and saving custom amplifier presets.
Details MIDI CC messages for controlling amplifier functions.
Recalls presets using MIDI Program Change messages.
Defines MIDI control combinations for various functions.
Commands for backing up, restoring, and transferring presets.
Sysex for dumping current settings and saving presets remotely.
Defines the bit structure for sending preset data.
Procedure for selecting the amplifier's MIDI channel.
Details rated power, clipping, frequency response, and hum/noise.
Specs for pre-amp controls, input impedance, and channel input levels.
Details effects loop parameters, equalization, and physical dimensions.
To Next Page
