Need help?Do you have a question about the Peavey PV1600 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Channels | 2 |
| 2 Ohms Per Channel | 800W |
| 4 Ohms Bridged | 1600W |
| Total Harmonic Distortion | < 0.1% |
| Signal-to-Noise Ratio | > 100 dB |
| THD | < 0.1% |
| Frequency Response | 20Hz - 20kHz |
| Input Sensitivity | 0.775V |
| Input Impedance | 20k Ohms |
| Damping Factor | >300 |
| Dimensions | 19" x 3.5" |
Inspect the amplifier during unpacking and save packing materials for potential returns.
Describes rack mounting requirements and dimensions for the amplifier.
Guides on rack mounting, connecting to speakers, and initial power-on procedure.
Individual Input Sensitivity controls for each channel to adjust signal level.
LEDs indicating AC mains power supply and channel operational status.
Indicators that illuminate when the channel output signal level exceeds 1 V RMS.
LEDs that illuminate when DDT compression is active on the associated channel.
Heavy-duty rocker switch to turn the amplifier's main power on or off.
Limits current to the power transformer, protects against faults and overheating.
Standard IEC power connector for the AC mains cord.
Four 4-conductor Speakon connectors for connecting speakers.
Intake for the two-speed DC fan supplying cool air to the amplifier.
Combo XLR/1/4" phone jack for balanced and unbalanced audio inputs.
To Next Page
