EFX Level
is is the master output level control for the EFX mix. e output level sent to the EFX Send jack is controlled by the Channel Level
Control (10), the channel EFX Send controls (8), and by this master control. e 12:00 position is the recommended setting for this
control.
Headphone Level
is knob sets the headphone and control room output levels. To avoid damage to your hearing‚ make sure to turn the dial fully coun-
terclockwise before using headphones. Slowly turn the knob clockwise until you reach a comfortable listening level.
Compressor Control
Adjusting this knob clockwise lowers the threshold of the compressor, thereby increasing the amount of compression. e compressor
ratio is in the 4:1 range, varying with signal levels and the amount of compression. is is useful for controlling peak levels from live
sources. e compressor is aer the master level control(26), and before the main outs (35) and the USB port(39), so it can be used to
tame vocals being recorded into a DAW. You can audition the eect of the compressor by switching it in and out with the Enable
switch (14). When the compressor is active, the adjacent red LED will illuminate.
Level
is is the master level control, which controls the overall level sent to the main outputs (35) and the USB port (39).
Headphone Output
e Headphone Output is a 1⁄4” TRS (Tip= Le; Ring = Right; Sleeve = Ground) jack. e signal sent to this output is normally the
Le/Right mix. When the "To Control Room" switch (17) is engaged, the USB return signal is also sent to the headphones.
24
25
26
27
23
PV®6 Front Panel
To Next Page
Loading...
Need help?
General
