High EQ adjustment. In edit mode this knob controls the Level or amount of Delay effect. All the way to the
left is zero and all the way to the right is max.
This is the individual preset volume. In Edit mode this knob controls the amount of Reverb.
Turn it up, ours goes to 13!
This knob allows you to reduce the power output of the amplifier. Don’t confuse this with the Master
Volume control. Power Sponge adjusts the amount of power the amp is capable of producing. This circuit
allows you to get that full on cranked sound at bedroom levels. The Power Sponge can adjust the maximum
output of the power amp from 100 Watts all the way down to 1 Watt.
This function requires a Sanpera
®
I or Sanpera II foot controller. Waste no time in making that purchase—
the looper will allow you hours and hours of fun. You can record any 30 plus seconds of anything, switch
your tone (preset), and play over top of your recording. For example, try recording a bass track, then
change your tone to a lead tone and play over the top! Note the LED that corresponds to the looper on the
encoder will turn on when recording or playing back the loop.
Edit mode simply changes the 5 amp controls to their alternate function as listed on the bottom of the
encoder. When in Edit mode the Edit mode LED will either be green if you are editing Effects, or red if you
are editing Stompboxes. To enter Edit mode simply press either the Stompbox encoder (Item 2) or the
Effects encoder (Item 4). To exit Edit mode simply press the same encoder again.
8
9
10
11
12
13
1
2 3 4
0
12
0
7
8
1
2
3
4
5
6
10
11
9
12
13
1%
50%
100%
inst/stomp amplifiers effects
aux inUSB phones
preset name
turn to search
press to select
P1 P2 delay feedback delay level reverb level
push to select channel/
hold for tuner/menu
push to edit/hold to bypass push to edit/hold to bypass
edit mode
pre-gainmodel presetspresets low mid high post-gain master
guitar
input
power
sponge
looper
tap tempo
VIP-3
VYPYR
®
To Next Page
Loading...
